If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What did you use for the handrail standoffs? Did you just bend some round bar, 1/2 inch maybe? I like the way you incorporated the handrail to be the mid rail also.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
Yes mmw 1/2" solid round stock 4"pcs bent at a 1-1/2".Also ran short on standoffs notice the lower railing on the building the 2 middle ones are not installed yet need to go back tommorrow after i pu more round stock.After posting this thread i also noticed in the pic i left my torpedo level on the top rail building side also,went back today and recovered it.