Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Handicap ramp /Pipe Railing

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Handicap ramp /Pipe Railing

    Here are a few pics of a railing i did this past week.36" Top rail 20"mid all 1-1/2" schl.40 pipe.
    Attached Files

  • #2
    What did you use for the handrail standoffs? Did you just bend some round bar, 1/2 inch maybe? I like the way you incorporated the handrail to be the mid rail also.

    Comment


    • #3
      Yes mmw 1/2" solid round stock 4"pcs bent at a 1-1/2".Also ran short on standoffs notice the lower railing on the building the 2 middle ones are not installed yet need to go back tommorrow after i pu more round stock.After posting this thread i also noticed in the pic i left my torpedo level on the top rail building side also,went back today and recovered it.
      Last edited by admweld; 10-17-2010, 04:56 PM.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.