Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Drilling depth for posts in concrete

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Drilling depth for posts in concrete

    I can't remember where or when I heard it. But I've always used one and one half times the material thickness for the depth of a hole for pipe or tubing.

    So a one and a half schedule forty pipe would be approximately three inches. (1 7/8" X 1.5 would be 2 3/4")

    I don't believe I pulled this out of the air. I'm comfortable with saying it's something an engineer or someone close to one told me.

    Am I wrong?

  • #2
    I belive you are correct, but remember that's minimum.

    Comment


    • #3
      Originally posted by Ray C. View Post
      I belive you are correct, but remember that's minimum.
      I'm glad you mentioned that. It is the minimum.

      Comment


      • #4
        A little diffrent but same princable.

        I always use 1.5 of the outer dimension for my depth. My experience comes from some college and working as a rigger for some time. My reasoning is this, if you are bolting something up and you only screw in the bolt 1/2 of the OD of the bolt you are not getting max tensile strength of the bolt you must go the OD+1 turn to get max tensile strength out of the bolt. I always shoot for the max, you wouldn’t help pin a weld would you? No you want a full pin. But this is max not min so you make the call on what you need.

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.