Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

At The Track Dirt Bike Service Tray

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • At The Track Dirt Bike Service Tray

    If you are like me and ride dirt bikes than you are also like me and have to do minor repairs while at the track from time to time. The problem here is that some times you place the small bolts on top of the bike seat nice and safe. But when it comes time to reassemble the bolts are missing, knocked off and lost in the grass. The other issue is spary cans like chain lube, WD40, air filter oil and silicone don't balance well on the seat.
    Today I decided to make a tray that will assist with 'At The Track Servicing"

    With a section of tube and a biscuit cut from a round bar of weldable ali I clamped the two together and wire brushed them.

    Attached Files

  • #2
    With the parts clamped and cleaned it is time to tack weld them together.

    Attached Files


    • #3
      Time for a test fit.
      The only spray can I had at hand was this enlarged model.
      The ones in my track box are normal height.
      The can fits nicely into the holder.
      I gave the holder a quick sand just for the photo.

      Attached Files


      • #4
        With some 1.6mm or 1/16" ali tread plate I folded up a tray, welded the corners and ground the weld back square with the sides. I then filled it with water to test for leaks. No leaks after an hour so this tray if required can be used to catch an oil change.
        I cleaned all the surfaces with some spirits and dabbed some silicone to the bottom of the spray can holder and positioned it in the tray.
        I placed a heavey item on top and let it dry.

        The service tray is ready for action this weekend. I will attach a system to quickly fix the tray to a bike while being serviced but for now the tray itself is finished.

        Attached Files
        Last edited by Jigantor; 09-30-2010, 05:55 AM.


        Special Offers: See the latest Miller deals and promotions.