Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Lincoln Handymig 100 question?

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lincoln Handymig 100 question?

    Hey guys, i have a backup welder apart from my 210. Its for when i just wanna flux weld something and dont wanna set up the bigger one.

    My question is that the wire is always hot. I heard from some people that this is normal on this model of welder. When i push the trigger, the wire comes out perfectly. Its kinda a pain in the ***, cause i am so used to the wire only being hot when the trigger is pushed.

    If anyone else can enlighten me thanks, as i don't wanna fix something that isn't broken.

  • #2
    I had from, a deal, a little 90amp century. The wire was always hot. I did not like it. The welder was to small anyway so I sold it. I got 100 bucks for it, way more then it was worth. I think the always hot wire is normal for the lower amp (cheap) machines.


    Special Offers: See the latest Miller deals and promotions.