Announcement

Collapse
No announcement yet.

Aluminium Clip Board

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Inspired to make the mega board

    I made the super size board for 11x17 sheet.

    Rounded and smoothed edges all around with Tig.

    Used a 2x2 square cube previously made,,, as a pen holder, we use a red and green pen so I made two holes and put smaller holes in bottom to drain oil that gets on pens.

    The cube also holds the top edge up a few inches to keep it from sticking and give it an upward angle to write on.

    So thanks for the idea, the little store bought boards just wasn't up to the task.
    Attached Files

    Comment


    • #17
      pick of the cube.
      Attached Files

      Comment


      • #18
        Great job mate.
        That is a lot of TIG welding the edge.
        Setting up the work shop can save so much time and looks great to others that see your improvements. I just use scrap most of the time so it only costs a little time. Every one that sees my clipboard asks " Where did you get that from"
        With pride I answer "I made it would you like one"

        Great job keep it up!

        Ji
        Grip it and Rip it

        Comment


        • #19
          Thanks, JI,

          I'm going to take it to the guys at work today. Kind of want to keep it, LOL
          but I'll make another like yours that is more practical for personal use.

          That one is just too big, but holds the charts well.

          Comment


          • #20
            Before you hand it over make sure you place your name above the clip line.
            It will make you feel great every time you see it.

            Ji
            Grip it and Rip it

            Comment


            • #21
              I almost put my name on it but didn't,
              Last edited by Hardrock40; 10-23-2013, 11:30 AM.

              Comment


              • #22
                So did you get to keep your job?
                Did you make another one?

                Ji
                Grip it and Rip it

                Comment


                • #23
                  Hey JI, well yes nothing was mentioned. I think they know how frustrated we all are at the present time.

                  I had to delete that comment, after reading it again , just seemed inappropriate.

                  I haven't made another board just yet, thinking of making myself one now, LOL

                  Comment


                  • #24
                    That is good news
                    When you make the next one try and find a way to put your name on it
                    It will make you smile every time you see it

                    Ji
                    Grip it and Rip it

                    Comment

                    Working...
                    X