Announcement

Collapse
No announcement yet.

miller 140 auto ser

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • rubadub
    started a topic miller 140 auto ser

    miller 140 auto ser

    If you are going to weld two pieces of metal together, one is 1/16'' thick and the other is 1/8'' thick. What does the manual say, do they give you an approximate setting for the two. Or is it only for one size only.

    Rob





    Thanks Rob

    http://www.1969supersport.com
    Last edited by rubadub; 12-11-2007, 01:17 AM.

  • rubadub
    replied
    Sounds good, thanks Hank


    Rob

    http://www.1969supersport.com/

    Leave a comment:


  • Hankl
    replied
    Rob,

    I was taught that you set up for the thicker piece, and dwell less on the thinner metal as you do your pass. Best thing to do is take a couple of test coupons, and just run a few beads to see what setting and speed works for your skill level.

    Hank

    Leave a comment:

Working...
X