Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

lawn tractor

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • lawn tractor

    looking for plans to build a small lawn tractor using 2X3 tubeing for a frame
    about a 10 t0 15 hp any ideas? thanks

  • #2
    i would just buy a used one i have seen them sell for as low as $100 around here!!!!!!!


    • #3
      Just copy one that way your parts will fit...Bob


      • #4
        Easy to build lawn tractor from spare parts

        All from scrap laying around, Green John Deere paint was $12. Yellow is just rustoleum. Turns on a dime, but needs better brake. Selling this for $150 when I get a real Garden Tractor.
        Attached Files
        Last edited by; 04-18-2006, 09:22 PM.


        Special Offers: See the latest Miller deals and promotions.