Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

miller 140 auto ser

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • miller 140 auto ser

    If you are going to weld two pieces of metal together, one is 1/16'' thick and the other is 1/8'' thick. What does the manual say, do they give you an approximate setting for the two. Or is it only for one size only.

    Rob





    Thanks Rob

    http://www.1969supersport.com
    Last edited by rubadub; 12-11-2007, 12:17 AM.

  • #2
    Rob,

    I was taught that you set up for the thicker piece, and dwell less on the thinner metal as you do your pass. Best thing to do is take a couple of test coupons, and just run a few beads to see what setting and speed works for your skill level.

    Hank

    Comment


    • #3
      Sounds good, thanks Hank


      Rob

      http://www.1969supersport.com/

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.