Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Gamecock

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gamecock

    Just finished this gamecock for a woman to give to her husband as a birthday gift.. turned out pretty good..
    Attached Files

  • #2
    beautiful work

    Comment


    • #3
      Nice Bird

      Jim,

      That's a real good lookin' bird. I don't see how you talented guys come up with that stuff.
      I can only see things in 90s and 45s and even then a 22 1/2 gives me trouble.

      Before I had the hardware removed from my leg (june) I built a box... and it was out of square.

      On top of that your welding looks way better than mine.

      Keep up the good work,
      Bob

      Comment


      • #4
        Thanks Steve and Bob for the comments... all welding done with a millermatic 90, using flux core wire. Bird cut out with a hobart 250CI plasma.
        Jim

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.