Announcement

Collapse
No announcement yet.

magnetic ground

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • magnetic ground

    a while ago i picked up one of these gizmos

    http://cgi.ebay.com/Switchable-Magne...QQcmdZViewItem

    its a switchable magentic ground clamp.. i like it alot and its nice to get the grounding point closer to the point of weld for my MM210.. i was just curious if you guys think that the magnetic field that it has would screw up my welding at all..

  • #2
    While in the company weld shop one of the guys was using one of those on a big (BIIIIIG) header. On one of the last welds it put an arc burn in the middle of the pipe. Last I saw it, it was flying out the door.

    Comment


    • #3
      I have read . . .

      I have "read" that a magnet anywhere near a MIG puddle will pull the puddle and deform your bead . . .
      Millermatic 251
      Lincoln AC/DC "Tombstone"
      Milwaulkee Grinder 4 1/2"
      Clark Grinder 4 1/2"

      Comment


      • #4
        Try tigging next to a strong magnet sometime. Doesn't work so well.

        Some objects and projects are more suited for a magnetic ground than others. If you were doing a fuel cell, for instance. You could slap the magnet on a side far away from your work area and not have to worry about the clamp disrupting your ability to set the box flat. Working on a welding table would resolve this, but sometimes that's not always possible.

        I wouldn't throw away a standard ground clamp for a magnetic one, but I can see where it might be handy to have from time to time.
        Syncrowave 250DX
        Invison 354MP
        XR Control and 30A

        Airco MED20 feeder
        Thermal Dynamics Cutmaster 81
        Smith O/A rig
        And more machinery than you can shake a 7018 rod at

        Comment


        • #5
          Ac/dc..??

          Once a field has been magnetized, DC is worthless and you have to switch to AC (not a great alternative). I don't know if your tool would do this or not??

          TacMig
          We depend On:
          Miller | Esab | Lincoln | Fronius
          Baileigh | Drake | Eagle | Knuth
          Victor | Harris | Smith | Bessey
          Snap-On | Hilti | Ingersoll Rand
          Burco/Koco | Onan | BobCat
          Tracker | Infratrol | AmeriCast

          We belong to or support:
          American National Standards Institute
          American Welding Society
          The Welding Institute
          Fabricators & Manufacturing Association Int'l.

          Anderson & Co. LLC
          Metal Cr
          afters

          Comment


          • #6
            After using those red triangle magnetic squares, I dont have much time for magnets unless you use the real small ones to hold your work long enough to tack it. Unless its me, the two were never made to use together.
            Ken

            What else is there besides welding and riding. Besides that

            Miller Thunderbolt XL 300/200 AC/DC
            Hobart Handler 187
            Dewalt Chop Saw
            4" Air Grinder
            Die Grinder
            Rigid Drill Press
            Kellogg 10hp Air Compressor


            2009 FXDC

            Comment

            Working...
            X