If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It shouldn't be too hard to get you started without plans. You know what you want to haul on it right? You have a receiver hitch right? So get some tube for inside your hitch. Do you want it to hinge up or stay flat? So if it hinges maybe add some extra length to your hitch tube. Just make the frame from some angle iron like 2x2x3/16" or so. Then put some exp metal on the angle frame. If you want it to hinge just have the frame made and see what you need to hook it on your rec tube. Shouldn't be too hard to make all the parts...Bob
Depending upon the weight of your cargo, you might want to add one or more braces at a right angle on each side of your tube going into the receiver and welded to the frame of your cargo carrier to distribute the weight better. I added a swing away turnbuckle to one side of a swing out hitch mounted bike carrier to keep the load from oscillating...one end with a eyebolt to a welded tab on the carrier and the other a hook end to attach to one of the chain hook tabs. For a cargo hauler it wouldn't hurt to add one to the other side as well...they're cheap insurance.
Miller 251...sold the spoolgun to DiverBill.
Miller DialArc 250
Lincoln PrecisionTig 275
Hypertherm 900 plasma cutter
Bridgeport "J" head mill...tooled up
Jet 14 X 40 lathe...ditto
South Bend 9" lathe...yeah, got the change gears too
Logan 7" shaper
Ellis 3000 band saw
Hossfeld bender w/shopbuilt hyd.
Victor Journeyman torch and gauges
3 Gerstner boxes of mostly Starrett tools
Lots of dust bunnies
Too small of a shop at 40 X 59.