Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Shooting Bench

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Shooting Bench

    Made this shooting bench a few years ago when I was prairie dog hunting out west.

    The legs are removable and individually adjustable for uneven ground. They mount with shoulder bolts held in with wing nuts. They store inside the main tube for transport.The threaded rod on top is for height adjustment. Never did get any knobs put on the threaded rods.

    The main tube is 3" pipe with the union half welded in place. On the table top is a short piece of 3" pipe threaded for the other half of the union and welded to the table bracing. The union nut has rods welded in place to tighten and loosen the union so the top will swivel 360 degrees.

    The table top is 1/2" plywood with 3/16 stiffeners underneath. There are quite a few prairie dogs in Wyoming and North Dakota no longer with us so it has proven to be steady.

    The paint job is what I call prairie dog camouflage.

    Al
    Attached Files

  • #2
    Pretty spiffy; however, the shooter seat location is on the wrong side.

    Jerry in Anchorage

    Comment


    • #3
      Had a buddy I used to shoot with said the same thing.

      Al

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.