If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
wish I had a pilot licence. checked into it when I was younger but was way too expensive. wish I could afford to go to school. good luck with the hunt. 32 years old and I've never been in a plane. Only once, in a 747 as an infant. mabey thats why I have a crazy fascination with flying. latley I've been checking out whats availible on the market for kit planes. Its hard to get near flying in a small town. when I was younger I tryed to get a job doing anything just to get near flying. loading bush planes, cleaning , **** I would of even polished the wheels for crying out loud. with no success I then checked into student loans, schools etc. The prices were unbelievable. not to mention living expenses etc. you could make a fortune up here in B.C. flying little bush planes around. I'll be one of those guys that waits untill he's 60 to get his licence, untill then I'm stuck with my flight simulator lol. mabey one day I'll have the money and room to build one. I've been doing alot of research on manufacturing proccesses for fuselages, fuselage frames, engine mounts etc. for the past couple years. hope you find someone qualified through this post .................................................. .....
Dewalt Bench grinder
Mastercraft miter saw
Mac air tools
Mac hand tools