Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Subaru twinscroll manifold

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Subaru twinscroll manifold

    It's work in progress, missing flanges and few welds, I just fixed it on plywood pieces to show how it should look assembled




    304 stainless tubing, 42.4mm diameter 1.5mm wall thickness
    I use Diversion 165, foot pedal and backpurging from second cylinder.
    Oh, and that's my first welding attempt

  • #2
    Sweet job. Like the plywood holders. Wish my first job was that nice.

    Comment


    • #3
      Thanks!

      I'm going to weld flanges than bolt it to table before final welding of straight runners. Will this be sufficient to prevent distortion?

      Or flex tubes may be another easy solution..

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.