If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The weld looks O.K. but it's hard to tell if you got proper penetration. Also, why didn't you weld all the way around? To help better critique your welds, I along with several other members (I'm sure) would like to know the material, material thickness, machine, amps, filler and a cut-off side view to see your penetration. Otherwise all we are looking at is a bead. However, you bead looks good but remember, looks are deceiving especially in welding!
Good luck and hope to see some more!
We depend On:
Miller | Esab | Lincoln | Fronius
Baileigh | Drake | Eagle | Knuth
Victor | Harris | Smith | Bessey
Snap-On | Hilti | Ingersoll Rand
Burco/Koco | Onan | BobCat
Tracker | Infratrol | AmeriCast
We belong to or support:
American National Standards Institute
American Welding Society
The Welding Institute
Fabricators & Manufacturing Association Int'l.