Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Heavy Duty Truck Flatbed to Trailer Conversion

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Heavy Duty Truck Flatbed to Trailer Conversion

    Here is one of many welding projects I have on my plate. We purchased a used 2000 Peterbilt 330 Truck with a River City Body Co. 24' x 96" Flatbed on the truck. The truck will be reworked to go under our Smeal 8TSR Pump Service Rig. My dad has a trailer we have been threatening to rebuild for years now, made entirely out of 1/4" wall tubing; 2x2, 2x4, 3x6 to name some of the material being salvaged from it.

    Here are the details of the Flatbed construction direct from the manufacturer:

    Heavy Duty Flatbed
    5" x 3/16" Formed Channel Outer Rail
    4" x 3/16" Formed Channel Crossmembers
    12" On Center Crossmembers
    3/16" Exterior Stake Pockets
    3/8" x 2" Rub Rails
    C6" x 8.2 Industrial Channel Longsills
    1 1/8" AHeavy Duty Flatbedpitong Hardwood Floor
    FMVSS Federal Lighting

    Here is the plan:
    Number and Remove the decking in sequence. Salvage the U Bolts used to tie the bed to the truck frame. Install a track made from angle iron and tubing as a pipe slide channel on each side. Rip the appropriate boards in the deck to reinstall back into original positions.
    Using the metal salvaged from the other trailer, construct a frame to run under the Longsill of the flatbed and construct suspension frame for the axles, suspension and tires we have.
    Construct a Tongue for the 48x18x18 Box that came with the bed and install a good Bulldog Heavy Drop Leg Jack. Finish off the tongue pull with an Attwood 25K Flatface 2 5/16" Hitch.

    I will provide pictures of this build, in sequence, as the work begins and progresses. Beleive it or not, TX Dot will require us to provide pictures of the reconstruction along with the Flatbed Serial Number and ID Tags from the axles and hitches to calculate the carring capacity and GVWR and then prove that the trailer was constructed from legally obtained parts and materials, i.e. no stolen parts.

    Stay tuned, maybe this rebuild might help me win a future Miller Giveaway.

    Charlie Johnson

  • #2
    is i was reading my first thought was what the dot laws were in TX. but you seem to have your s*it together and i can't wait to see some pictures.
    I've been wanting to make a trailer out of a ramp truck. but I'll never get to it.

    Comment


    • #3
      I'de be safe and use new U bolts.
      Keep us posted.

      Comment


      • #4
        I'm looking forward to this thread. I'm in the middle of a similar project of my own to make a trailer out of a 22 ft truck box. What GVWR are the trailer to have? Any estimates on dry weight?

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.