Announcement

Collapse
No announcement yet.

how is this weld?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • how is this weld?

    This was me welding a piece of scrap with my lincoln weld pak flux core welder. what do you guys think of it? im still learning. thanks
    heres the link

    http://i177.photobucket.com/albums/w...r27/myweld.jpg

  • #2
    Hang on a sec, I need to go get my glasses....


    Do dee dooo..... umph.

    Oh its still fuzzy.

    Can you take another pic thats in focus?
    Last edited by SignWave; 11-28-2007, 10:11 PM.
    Will it weld? I loooove electricity!

    Miller 251/30A spool
    Syncro200
    Spectrum 625
    O/A
    Precix 5x10 CNC Router12"Z
    Standard modern lathe
    Cheap Chinese mill that does the trick... sort of...
    horizontal 7x12 bandsaw
    Roland XC540 PRO III
    54" laminator
    hammer and screwdriver (most used)
    little dog
    pooper scooper (2nd most used...)

    Comment


    • #3
      And put a coin or something next to the piece, to give us some scale.

      Comment


      • #4
        welding scrap

        what position are you welding in? The only negative thing i can say is to slow your travel speed down a little. try practicing running stringers on flat plate 6 inches by 8 inches. cover the plate and lets see what that looks like. focus on uniform width and highth. Let's see some 1g,2g,and 3g positions. I believe your welds would be acceptable to an inspector, but remember this is an art.
        Try to make every weld better than the last one. Also it doesn't hurt to use that grinder and weld clean steel.
        Peace

        Comment

        Working...
        X