Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Plant Stand

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Plant Stand

    I haven't made these for 6 or 7 years. So today i dusted off my powered scroller and my twister and made one for a sample for orders. These are straight out of the shopoutfitters idea book of years ago. I used their scroller except i motorized it and i used my twister for the 1/2" center bar. The rest is 3/16x1 flat and 1/4" round for the basket holder...Bob
    Attached Files

  • #2
    That's cool and doesn't look extremely hard to build.....NICE Jim


    Special Offers: See the latest Miller deals and promotions.