Announcement

Collapse
No announcement yet.

Welding V-Blocks

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Welding V-Blocks

    Hi Guys,

    I just finished making my first welding V-block. I need a bunch of these for a project and just couldn't buy them where I live. Frustration leads to invention - and I thought I would share.

    The base is 1X2" channel. I welded on some 1" angle and spaced it off the side by the thickness of my square. This left a gap in the middle for the 2" angle. I carefully ground the top of the channel and the base of the angle flat with my 12" disk sander. I put on an inch of weld to hold things in place as I didn't want to warp the angle.

    Then I cut out the fillet in the angle and ground the front and back flat.

    Here's the finished project. I tested the top of the 2" angle and it was perfectly level with my bench - close enough for welding.



    Synchrowave 180SD
    Millermatic 252
    Hypertherm 35
    MetalMaster 14" Saw
    Other random stuff.

  • #2
    Great job they look like they will work well...Bob
    Bob Wright

    Spool Gun conversion. How To Do It. Below.
    http://www.millerwelds.com/resources...php?albumid=48

    Comment


    • #3
      Well thought out, a similar construction could be used to make a centre
      drilling jig.

      Comment


      • #4
        Coburn you built what I had been thing about. Well thought out as well as well done.

        Comment

        Working...
        X