Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

more

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • more

    Sorry Gang but I am having problems getting my computer to upload some of these pics .After restructing the rear 6' of the bus to account for the last three crossmember that were removed I built a well with three steps and cut the center of the bumper and threshold at the door corners and hinged it with two more steps that fold down leaving just over 6' of headroom in the door opening.When closed up for transport all that you see are the two small verticle cuts in the bumper.
    To support my habit I ialso take on paying work.This is a 22' x102" wide x 8' tall grain body for a local farmer.The first is the main structure , framing the sides ,the third is the mounting for the 30 ton hoist cylinder and last is the sides up. Bill
    Attached Files

  • #2
    Looks good. Keep posting progress.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.