If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The bottom 4 " solid stock snapped in half bending the top 4 " solid stock enough for our good old press to make funny faces and funny noise.
I would of changed the snapped bottom stock but the customer wanted me to straighten everything and welded back together.
I'm not done yet but here's a few pics
I love doing this kind of job.
There was stops for the grab arm that were damaged and should have been fixed a while ago and the grab arm broke them futher extending the cylinder arm at it's fullest and hitting the 4" round stock snapping it completely bending the entire quick attach. I would have took a pic of before I straighten it, but only picked my camera during my lunch and I had it straight on the table by then.
Lots of force on these cylinders, I couldn't believe it that they said there was no damage to the cylinder