If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
as I was cutting pieces for the drivers side I cut some for the passenger side also, so the second side went very quickly. The passenger side is about 1/4" lower than the drivers side, so tomarrow I'll tweak that and cut the ends off and make caps for them.
This has been a fun build, when I'm finished with the front I plan to make a rear also. To finish the front I have to cut off ends and make caps, cut in some fog lights, add a "baja" bar, mount some KC's and add recovery points. Still debating on a coating for it, I am torn between powder coat and spray on bedliner, I am leaning toward the bedliner only because I want to do my nerf bars also and I think the bedliner would be more durable....but who knows?
I have one of those in my short list to fit my work truck.
Me thinks it is time to move it up to the top.
Live Right Have Fun
Hypertherm PowerMax 1000
20" x 40" CNC Mills (2)
16" x 60" engine lathe
65 Ton edwards iron worker
3/16' x 24" power slip roll
16' power feed mitering bandsaw
and other fun toys