If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Nice looking job.
I did a similar thing with HR angle that I used for a table. I mitered the corners and the top sits down inside. The rest of the base was wrought iron with one inch square twisted legs and scrolls down to the legs. The visible parts of the angle were textured with a grinder, wire brushed and covered with automotive clear coat.
Miller Mig 130XP
Linde VI206 W/Mig
L Tec Plasma PCM32i
Pneumtic Forging Hammer 75#
Mechanical Forging Hammer 65#
Makita Chop Saw
Bader 72" Belt Grinder
Bader Knockoff 72" Belt Grinder
Miller 211 A.S. and Spoolmate 100
Stickmate LX 235 AC / 160 DC.
Clarke 180 EN Just in case
Spectrum 375 X-Treme.
O/A Medium Radnor Torch, Large Victor Torch.
Milwaukee 14" Chop Saw.
4 x 6 Horizontal Band Saw.
Rockworth 80 Gallon 2 Stage 16 SCFM @ 175 PSI , 15 SCFM @ 90 PSI.
Jackson Passive shade #5 for the plasma.
I almost forgot the Hobart XVP AD Hood.