Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

SS Art Work

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • SS Art Work

    20ga Dull Finish Stainless steel that I hit with a 5" blending disc for the design.
    Attached Files

  • #2
    pretty neat. could you link me to the blending disc that you used?

    Comment


    • #3
      http://www.aaabrasives.com/products/...stainless/9621

      Comment


      • #4
        SST Artwork

        Nice looking job.
        I did a similar thing with HR angle that I used for a table. I mitered the corners and the top sits down inside. The rest of the base was wrought iron with one inch square twisted legs and scrolls down to the legs. The visible parts of the angle were textured with a grinder, wire brushed and covered with automotive clear coat.

        Comment


        • #5
          I also made some custom hangers for it so it's less then 1/8" off the wall.

          Comment


          • #6
            Looks nice man.

            Comment

            Working...
            X
            Special Offers: See the latest Miller deals and promotions.