If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Short lengths of I-Beam such as this are great for making heavy duty horses.
Weld a couple lengths of channel on and use angle iron for the base and you're good to go.
I have a couple that I use all the time for mounting a vice, a tubing roller, a pipe bender, etc. One is the same height as my welding table, which works great for larger pieces.
Not useless, but reallly doesn't have much "commercial" value. I get my beams out of my buddy's scrap dumpster (runs a large fab shop).
Syncrowave 250 DX Tigrunner
Dynasty 200 DX
Miller XMT 304 w/714D Feeder & Optima Control
Miller MM 251 w/Q300 & 30A SG
Dialarc 250 AC/DC
Hypertherm PM 600 & 1250
Wilton 7"x12" bandsaw
PC Dry Cut Saw, Dewalt Chop Saw
Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
Thermco and Smith (2) Gas Mixers
More grinders than hands
Nominal 8" flange width could be 31-67 lbs per ft.
Not very specific, is it?
80% of failures are from 20% of causes
Never compromise your principles today in the name of furthering them in the future. "All I ever wanted was an honest week's pay for an honest day's work." -Sgt. Bilko "We are generally better persuaded by reasons we discover ourselves than by those given to us by others." -Pascal "Since we cannot know all that there is to be known about anything, we ought to know a little about everything." -Pascal
Look up steel suppliers near Edison, NJ. Try Samson Metals or Metals USA.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24