If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It includes the die and for $299 it seems like just what you need.
Looks like a scaled up conduit bender with a hydraulic jack and as WyoRoy stated a frame that appears to be built out of shop scrap. The die appears to be die cast aluminum. How long will it last? I'm sure that bender won't bend some of the tight radius bends needed to build a race car chassis/rollcage even with a different die.
But I guess if all you need is large radius 90 degree bends that would do the job
Blondie (Owner C & S Automotive)
Colt the original point & click interface!
Millermatic 35 with spot panel
Victor O/A torches
Too many other tools to list
It is a choice of bending tube every week then get a $600-$1000 bender, if you need the occasional bend and roll cage that you wont go past 90* then get the bender I listed for $200.....die included.....a JD w 1 die will run at least $650