Announcement

Collapse
No announcement yet.

Clamps

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Clamps

    I searched this one already so I hope it hasn't been posted a billion times already, but I was looking for a source for tube/pipe clamps. I wanted to weld up a longboard rack for my mountain bike out of some tubing that could be removed using some split clamps, but I can't seem to find the ones I'm looking for. They basically look like a piston rod end with one bolt one each side, but are made out of some split tubing. Does anyone have any idea where I might find these?
    DYNASTY 200SD
    COOLMATE 1
    MM140AS
    SPOOLMATE 100
    SPECTRUM 625 X-TREME
    SPECTRUM 125C

  • #2
    Maybe these would work ?

    Split shaft collars

    These are from MSC, but Grainger, or McMaster would have them.

    Maybe some Hydraulic pipe supports would work, They are cheaper, and vibration isolators.
    Attached Files

    Comment


    • #3
      Thanks, that's pretty much what I'm looking for, I wanted something I would be able to weld some tubing to for a surfboard rack that I can clamp to the aluminum frame on my mountain bike kinda like this:

      http://www.amazon.com/gp/product/ima...sporting-goods


      But simpler.
      DYNASTY 200SD
      COOLMATE 1
      MM140AS
      SPOOLMATE 100
      SPECTRUM 625 X-TREME
      SPECTRUM 125C

      Comment


      • #4
        Forget MSC, Grainger, or McMaster

        There are some on Ebay cheap

        http://cgi.ebay.com/1-Shaft-Collar-D...item562fcf3abf

        Comment


        • #5
          Originally posted by bubba9459 View Post
          Forget MSC, Grainger, or McMaster

          There are some on Ebay cheap

          http://cgi.ebay.com/1-Shaft-Collar-D...item562fcf3abf
          Mcmaster is less than half the price of the one you linked to on ebay.
          Part number 6436K18 @ 3.94 each.

          Here is another good source https://www.surpluscenter.com/sort.a...shaft%20collar

          Comment


          • #6
            Thank you Now all I gotsta do is design it
            DYNASTY 200SD
            COOLMATE 1
            MM140AS
            SPOOLMATE 100
            SPECTRUM 625 X-TREME
            SPECTRUM 125C

            Comment


            • #7
              I would not recomment clamping to the aluminum frame unless you actually MUST, you could run the risk of crimping the tube slightly and weakening it. There should be some threaded holes located near the seat close to where the brake is typically and there should be some extra holes down around where the tabs were the rear wheel mounts. The example rack you posted attaches at these came spots. If your bike does not have these then I could see a reason to clamp to it.

              Many years ago I built a rack for a mountain bike to hold a compound bow so I could ride down to the archery range. I did it once, it was such a large sail (bow in a case) that it made it hard to ride if there was any breeze, and I gave up and never used it again.

              -Dan
              Owner
              DW Metalworks LLC
              Miller Trailblazer 302
              Miller 8RC Feeder
              Miller Passport Plus
              Miller Dynasty 200 DX W/Coolmate 1
              Hobart Handler 135
              Hypertherm PowerMAX 30
              Smith O/A Torch Set
              Plus more tools then my wife will ever know about....

              Comment

              Working...
              X