Announcement

Collapse
No announcement yet.

going to be making home made pressbrake, jack sizes?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Sure you can make what you need. It may not last as long from being used and will get some marks in it but you can rework it...Bob
    Bob Wright

    Spool Gun conversion. How To Do It. Below.
    http://www.millerwelds.com/resources...php?albumid=48

    Comment


    • #17
      will it finished the press brake off. works awesome. tryed to bend some 5mmx about 300-400mm wide flat bar, got it to bend a little bit but then i stoped as the lower dies where turning into a banana

      so far ive bend 5x100mm no problems, 3mm x about 250 no problems.

      also too it will bend way last 90* which is a good thing i guess

      i am thinking about making some differnt lower dies for when i want to bend some heavy section. just got to work out a design

      Comment


      • #18
        how about pictures
        Nick
        Miller 252 Mig
        Miller Cricket XL
        Millermatic 150 Mig
        Miller Syncrowave 200 Tig
        2-O/A outfits
        Jet Lathe and Mill
        Jet 7x12 horz/vert band saw
        DeWalt Multi Cutter metal saw
        Century 50 Amp Plasma Cutter
        20 ton electric/hydraulic vertical press
        Propane Forge
        60" X 60" router/plasma table

        www.youtube.com/watch?v=jTu7wicVCmQ
        Vist my site: www.nixstuff.com
        and check out some of my ironwork and other stuff

        Comment

        Working...
        X