Announcement

Collapse
No announcement yet.

Mag Drill Turned into a Drill Press.....

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mag Drill Turned into a Drill Press.....

    I made a table To turn my Mag drill into a drill press Works on all small pcs.I can drill stainless,Copper,Alum.,Plastic What ever.
    Vernon
    Attached Files
    Last edited by Vernon; 11-25-2009, 10:35 PM.

  • #2
    nice job it looks good

    Comment


    • #3
      That's smart.
      Jack Olsen
      The Garage • (And its slideshow)
      The Car • (And its slideshow)

      Comment


      • #4
        I've done that with a small segment of beam, in my trailer shop. Vernon, do you have the adapter to use twist bits in yours. I do and it is awesome. I have a Milwaukee and its almost new. My old drill press at the home shop does most of the grunt work.

        Peace,
        Paul

        Comment


        • #5
          nice work it so it should work well for your needs.

          Comment


          • #6
            Mag drill

            Originally posted by Paul Seaman View Post
            I've done that with a small segment of beam, in my trailer shop. Vernon, do you have the adapter to use twist bits in yours. I do and it is awesome. I have a Milwaukee and its almost new. My old drill press at the home shop does most of the grunt work.

            Peace,
            Paul
            Paul,

            No do not have the adapter to use twist bit in mag drill may get one some day.I have a Hougan 2 3/8" by 3" cap. That a a big hole. Well take care
            Vernon

            Comment


            • #7
              Big hole indeed, I would recommend the adapter and chuck. Cool plate press for your mag drill!

              Comment


              • #8
                Adapter

                Originally posted by Paul Seaman View Post
                Big hole indeed, I would recommend the adapter and chuck. Cool plate press for your mag drill!
                Does your adapter use a 3/4" shank With flat spot for set screw

                Comment


                • #9
                  Drawlings Of Mag Drill and Base

                  I just found some of my drawlings today of this Mag Drill. Draw this before I built the Mag Drill Base Many Years ago. Vernon
                  Attached Files

                  Comment


                  • #10
                    Originally posted by Vernon View Post
                    Does your adapter use a 3/4" shank With flat spot for set screw
                    Here is a picture of the Hougen adapter.
                    Caution!
                    These are "my" views based only on “my” experiences in “my” little bitty world.

                    Comment


                    • #11
                      Adapter

                      Jesus I know what a Hougan Adapter looks like wanted to see his adapter.But thanks for your picture. Vernon

                      Comment


                      • #12
                        I have to remove the entire base from mine and it mouts to the upper drive off the motor.

                        Comment

                        Working...
                        X