Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Wire Welder and Plasma Cutter on Same Cart?

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wire Welder and Plasma Cutter on Same Cart?

    I've found some items and materials to make a Free mobile cart to hold my wire welder, an Argon gas bottle, and a future plasma cutter....

    My question has to do with putting both of them on the same cart. Do you see any problem with the welder and plasma cutter spaced 4" apart and both facing outward and on the same cart?


  • #2
    Sounds alright to me, but you are the guy pushing them around...Bob


    • #3
      The one thing to be leary of is that you dont restrict air flow to the machines. As long as no vents are blocked you should be ok.


      • #4
        I plan on doing the same thing with a Spectrum 375 and my Hobart EZ125, so I guess I don't see a problem either. Post pictures when you get it done please.


        • #5
          That is what I did....
          I was careful to make sure I wasn't blocking any cooling openings/fans etc.
          So far, so good.


          • #6
            lots of room

            Bill make sure you can protect your wire because the plasma can send the sparks all around and they may pit the wire


            • #7
              How often is the "Side Door" opened on the wire welder?

              Cart is almost completed. I'm using the "hammered" paint. In placing the wire welder on the cart, I can put it to the left side. If I do place it on the left end of the cart where the handle is, I will have to always move the welder to open the side door.

              Are there many times when the door to the wire spool and adjustments has to be opened? Will this be a big problem?



              • #8
                Welder & Plasma Cutter on same cart

                I'm a hobbyist, after I justified my first mig machine (Millermatic 135) - I had to built the cart. Then there was the project that the 135 couldn't do - in came 200DX tig setup, and another cart... The angle grinder works great for most work, but I "really needed" a cutting torch - a Spectrum 375 fit the bill - and another cart? No I built a second story attachment to add to my TIG cart. Works great!



                • #9
                  Got a picture?

                  Could you post a picture or two of you carts?
                  Once the wire is loaded, do you get into your side panel very often?


                  Special Offers: See the latest Miller deals and promotions.