Announcement

Collapse
No announcement yet.

hard facing help

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • hard facing help

    i have been asked to hard face the augers and flight chains on an asphalt paver. i imagine a manganese based rod will be good for the abrasive wear. my trailblazer will not be in for another week, so hte machine that i have is the legend aead 200le, will this machine be enough, or do i need to pass this one on to another welder? i have hardfaced before, but with a 300d. i was working for someone else at the time. i would never consientiously own a lincholn. (spitting from bad taste)
    welder_one

    nothing fancy, just a few hot glue guns for metal
    www.sicfabrications.com

  • #2
    Burn a few rods on a piece of scrap & you will know.

    Comment


    • #3
      why wouldnt you be able to, what rod do you intend to burn that will require more than 200 amps....
      mm210
      maxstar 150

      Comment


      • #4
        looked at the amperage rating of the rods and....duh. dont know why i posted on this. maybe i'll add it to the "a thread celebrating the "not so bright"". i believe this one will fit right in....lol
        welder_one

        nothing fancy, just a few hot glue guns for metal
        www.sicfabrications.com

        Comment

        Working...
        X