Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

broken Vice !! need help!!

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • #61
    sorry for getting off track. i really just wanted to put a finish to the vice repair, letting all know its repaired.

    a BBQ
    some charcoal
    a card board box full of kitty litter
    a $13 pack of Nomacast 1/8"
    a TA-185
    and all is good to go.

    so i add myself to the list who say if you break your vise and have the option, give it a try. after all you got very little to lose and every thing to gain. i really su ck at stick so if i can do it anyone can.

    Comment


    • #62
      braze it

      put the brass to it and be done with it,

      Comment


      • #63
        Vice

        I would weld it with 7018 and take a chipping hammer between welds tap it all over to releave stress on the cast. I call it ping the metal. Had a lot of good luck with this. If it want weld with 7018 than it not cast steel and the vise is not good material for a vice anyways. Ni rods are not good for stress parts like vices. good luck.
        Vernon
        Last edited by Vernon; 12-08-2009, 03:26 PM.

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.