If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Looks very nice. Radius rails can be a pain. Did you make your own scrolls?
Do you have any closeups?
Miller 252 Mig
Miller Cricket XL
Millermatic 150 Mig
Miller Syncrowave 200 Tig
Jet Lathe and Mill
Jet 7x12 horz/vert band saw
DeWalt Multi Cutter metal saw
Century 50 Amp Plasma Cutter
20 ton electric/hydraulic vertical press
60" X 60" router/plasma table
Smith Oxyacetylene Torch
Miller Dynasty 200DX
Lincoln SP-250 MIG Welder
Clausing/Coldchester 15" Lathe
16" DuAll Saw
15" Drill Press
7" x 9" Swivel Head Horizontal Band Saw
20 Ton Arbor Press
Miller Spectrum 375 Plasma Torch
This is the PM from the original poster that I received in response to a request that he not steal the work of others. I thought my request (on the fourth post) was reasonable and not overly critical. If I am wrong I would certainly correct it. I see that he has also deleted his avatar.
Didn't know you were Judge and Executioner just trying to show some people a project and help a few out but I see you are more concerned with a 1/2" square picture that a teenage put on for me. Anyone on line can claim anything no proof needed I guess you are the resident smart ass in this forum so the people that have questions of the railing can just keep on asking to may other forums to go to where you don't have to listen to whining smart ass like you. Get Over It. "
Anyhow, I suppose he won't come back and answer questions,