Announcement

Collapse
No announcement yet.

Adapting spoolmate 100 on a 175

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adapting spoolmate 100 on a 175

    Yes I know this question have been posted many many times. I have posted a reply in this thread and I never obtain answer because this post is to old.

    http://www.millerwelds.com/resources...ight=Spoolmate

    These are my questions about this fitting and shorting the spoolgun

    In what kind of situation the spoolgun can be shorted? Is it very dangerous ( for the pc board? Is it possible to protect the board?

    Thank you

  • #2
    I don't know how you'd short it unless the drive or trigger wires came into contact with each other or the actual weld circuit, but that could happen on any spoolgun. Very unlikely at best.

    Personally I've never ever seen that happen

    Comment


    • #3
      I uderstand it is not very dangerous to break the pc board by a shortcut of the spoolgun.

      Comment

      Working...
      X