If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
All depends how big of a bottle your going to use and how wide your shelf is. If its a small bottle and it will set on the angle iron, you should be fine. Anything heavier or if your shelf is wider, than I would put some flat iron underneath your expanded metal.
What else is there besides welding and riding. Besides that
Miller Thunderbolt XL 300/200 AC/DC
Hobart Handler 187
Dewalt Chop Saw
4" Air Grinder
Rigid Drill Press
Kellogg 10hp Air Compressor
They were leftovers from a desk, or counter, from a medical business that went belly up in '83.
I've been hoarding them since then and finally found a use for them.
I was only going to use one but remembered that I have had them for 26 years and I'm not getting any younger.
I was going to put them on a wall in the garage but I don't have anymore room on my walls, or workbenches.
Millermatic 211 AutoSet w/MVP
Century 110 volt 90/110 MIG-Gone to my son, in Texas
Victor SuperRange OA
Milwaukee Cold Cut Saw
Milwaukee Portable Deep Cut Bandsaw
Milwaukee Hole Hawg
Jet Horizontal/Vertical Bandsaw
Jet MD-18 Mill Drill
Orbit Drill Press
12 Ton Floor Press
2002 E-350 V-10:
1983 F-150 4.9L 6
2004 Honda ST1300
2007 Suzuki LTA400F Quad
1997 Suzuki DR650