Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Drain pan

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Drain pan

    For those of you that dont look at Hobart. We are not a quick lube so I came to the conclusion that the jug on the bottom would be more work than it was worth so I just made a stand to sit the pan on which is adjustable for height. An old chair was the base and fence posts made the verts.
    Once I came up with the plan took about 30 minutes and I re-tuned it for height again, put a hanger made from a welding rod and hose clamp to hang the wrench which has a nasty habit of disappearing every time I need it. There is a set screw and the pole is telescopic.
    Attached Files

  • #2
    A little tool cart to reside by the hoist that I whipped up along with the drain pan.
    Attached Files

    Comment


    • #3
      Nice! I'm usually trying to find a pan thin enough to slide under the car!

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.