Announcement

Collapse
No announcement yet.

Trailblazer 302 house power

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Trailblazer 302 house power

    Question, does anyone know where to get a switchover box to hook the generator to the house, i want to totally disconect incoming power and power the whole house with the generator rather than just powering some of the circuits in the box, i realize i wont be able to run every thing at once but dont want to be limited either, thanks for the help!
    TB302
    Dynasty 200dx
    Hobart beta-mig 250
    Hobart Handler 140

  • #2
    Northern tool and supply.

    Comment


    • #3
      they only have the ones that work with select circuits though, was there tonight, thanks again
      TB302
      Dynasty 200dx
      Hobart beta-mig 250
      Hobart Handler 140

      Comment


      • #4
        Is this what you are looking for.

        http://www.northerntool.com/webapp/w...6624_200196624
        Trailblazer 302
        Lincoln SP-135-T
        Hobart Stickmate AC/DC
        Smith torch
        Spoolmatic 30A

        Comment


        • #5
          We have that very same set up at our office for use with my bobcat 250. We had it wired that way when it was built. We have a manually operated 300amp, Dual Pole, Dual Throw (DPDT), with center off switch from the local electric supply (I think ours is built by either Square D or Cutler-Hammer, can't remember). The load is connected to the center of the switch and then grid power is hooked to one side of the switch and a gen connection on the other side. With the center off, there is no chance of back feeding the grid and causing trouble. If you switch everything, then you would need to have some sort of indicator on the grid side just for the sake of knowing when commercial power is back on line.

          Here's a pic from another thread here on the messag board of our set up.


          SSS
          Last edited by SkidSteerSteve; 08-27-2007, 10:54 PM.
          Bobcat 250, MM 210, Syncrowave 180, Spectrum 375
          Cat 242B Skid Steer, Challenger (Cat/Agco) MT275
          1 Thessalonians 4:11-12

          Comment


          • #6
            Thanks guys, i guess the people at my local northern tool dont even know what they sell! i think both setups would work great! i will check it out
            TB302
            Dynasty 200dx
            Hobart beta-mig 250
            Hobart Handler 140

            Comment

            Working...
            X