Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

First welding project with MM180

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • First welding project with MM180

    This is my garbage can holder that i made with my MM 180 and is my first project. I used 1 inch angle iron for the lower frame and solid square tubing for the upper part of the frame and a piece of plywood for the base.
    Attached Files

  • #2
    Solid square tubing?
    Is it solid, or tubing?

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.