Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Welding gate

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Welding gate

    I have a 6 foot wrougth ron drive way gate that went throgh Hurrican Katrina and the hingesfroze up ad the gate fell. any advise on how to reattach

  • #2
    Welding a gate

    I have a six foot wrugth iron gate that went through Hurrican atrina and the hindges froze up. recently the gate fell off from the hinges. Would like to know what is the best way to reattach


    • #3
      Use any type of of welding process to weld steel.


      • #4
        Were u bee

        Hello Joe, U got any pics & ABOUT were are U located! Katrina got lots of territory! Just approx location would be good & a pic of damage would make it easier to suggest repairs


        Special Offers: See the latest Miller deals and promotions.