Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Novice seeking some advice.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    mini engine stand

    This is just somthing that I tossed together for working on small engines(snowmobile,atv,lawn mower).It works just like the full size ones just on a smaller scale.It`s a lot better than rolling the engine around on the work bench when your trying to put them together.
    Attached Files

    Comment


    • #17
      Sorry that`s my first post, I didn`t mean to put it there.

      Comment


      • #18
        Billy,
        That looks like one of my earlier attempts at a silhouette target for my Mini-14... A .223 leaves about a 1/2" copper-plated hole in 1/4" mild steel like crap through a goose.

        Comment


        • #19
          every time I use it, it seams like I have to drill new holes to bolt the motor on

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.