If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
1/4" SS for the Maxstar 200 is asking quite a bit. Set at max setting and see what happens. 1/8" tungsten. TIG torch plugged into - terminal ground in + terminal. Process selector in HF Impulse or you could set on Lift Arc. If using a foot control or fingertip remote your output switch should be in RMT STD. If you have the Maxstar 200DX leave out of pulse mode and make sure sequencer is out of play.
Thats about the best I can do on a vague question. Hope it helps.
If you are using an air-cooled TIG torch it is gonna get real hot....real quick.
If you are looking for recommended amperage settings try this link