If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Here is a link to the bender/brake that I built. I looked at a few pics from around the site and made the best with what steel that I had. Mine is a little on the heavy side I am thinking that I want to use this bender for the sheet metal maybe up to 1/8, and build a nice press brake for making brackets and such.
Good Luck and Please post pics when you start your build.
Miller 211 A.S. and Spoolmate 100
Stickmate LX 235 AC / 160 DC.
Clarke 180 EN Just in case
Spectrum 375 X-Treme.
O/A Medium Radnor Torch, Large Victor Torch.
Milwaukee 14" Chop Saw.
4 x 6 Horizontal Band Saw.
Rockworth 80 Gallon 2 Stage 16 SCFM @ 175 PSI , 15 SCFM @ 90 PSI.
Jackson Passive shade #5 for the plasma.
I almost forgot the Hobart XVP AD Hood.