hello everybody im new here just wanted to say hi first off, i have been recently practicing uphill welding and to no end cannot get a decent looking yet strong weld and was wondering if any of u can help,im just doing this for pratice so i know the method for when i start to build trailers, im praticing on 3/16 inch thick coupons by 4 inches .every time i do it , it seems to droop down and looks horrible, i was told to turn the heat down and did and still got the same results, is there some type of weaving method or wrist action im not doing, am i going to slow???? is it possible to make and uphill weld look like a fillet weld , using a mig welder with .035 wire with the mix, i can turn out other wleds no problem but the uphill is kickin my arse. i appriciate any advice or feedbak guys . thanks alot
No announcement yet.