Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Centerbolt Valve Covers

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Centerbolt Valve Covers

    New to the site:
    Trying to find some new rocker covers for my 4.3 Chevy motor yielded poor results. The only ones available in the US were Edelbrock's "Signature Series", which I thought were ugly, so I put my mind to fabbing my own. I built them a while back and dont have any "in progress" pics, but here's the final result:

    First I polished them


    Then decided to have them powdercoated:



    To make sure they were leak free I had the bases flycut by a machinist following welding.

  • #2
    Good job on the valve covers, How about some more details on the construction, photos of the inside, close upsk, etc.?

    Tim

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.