Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Glad I brought my welder in

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Glad I brought my welder in

    Hello All,
    Friday I came in to work to find that the Night shift techs had lifted the product conveyor belt and put it on a stack of blocks to raise it up.
    These blocks where in the center of the cross member,and the belt was wobbly. Good thing I brought my welder in. I welded the blocks together so that they could be used under the wheels. (see first pict). Filler was 3/32" 70-S2 @ 70 amps.
    Then I looked at the light shield made of cardboard and Duct tape. I took a few measurements and cut and welded one from some scrap SS. (see second pict), Filller 3/32" 308L . Still need to drill and mount to the end of the machine.
    Attached Files
Special Offers: See the latest Miller deals and promotions.