Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Beam or Bar joist reinforcement.

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    JB Fab, I pretty much agree with you, However there are a few other things going on at the ends depending how its being supported at the ends as to how the compession and the tension load goes through the beam to get to the top being under compression and the bottom under tension as you said.


    Special Offers: See the latest Miller deals and promotions.