Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Coffee measure

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Coffee measure

    The Egg McMuffin Cooker thread inspired me to take a pic of this ss coffee measurer. It holds enough coffee to make a 12 cup pot.
    When I got my tig I wanted to try a little stainless so I made this out of some scrap I had layig around. You can see on the bottom edge I got it too hot and melted through but was able to recover from it with a wavy edge.
    The stainless is .030".
    Attached Files

  • #2
    Good job

    Way cool! I may have to get myself a TIG outfit. That looks like it was fun.



    • #3

      That's pretty neat. It almost has an antique look.


      • #4
        Proof that small scraps can still be useful. I never let anything more than one inch in length go to waste.


        Special Offers: See the latest Miller deals and promotions.