Announcement

Collapse
No announcement yet.

weekend project

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • weekend project

    I built a corner table-its almost ready for a krylon makeover. I have a hard time welding FEM. I used 3/32 6013 at 55-65 amps.
    Attached Files
    Joe in NY

    Clarke 131E Arc Welder
    HF 4x6 bandsaw
    Hitachi 4.5" Grinder
    Craftsman Air Compressor

  • #2
    Thanks Reggie, I'll give it a try
    Joe in NY

    Clarke 131E Arc Welder
    HF 4x6 bandsaw
    Hitachi 4.5" Grinder
    Craftsman Air Compressor

    Comment


    • #3
      Corner Table

      Nice work! Not bad for a weekend project! I find that 3/32" 6013 at about 50-60 amps work well on thin square tube. FEM is a pain for me too! I am going to try reggie's tip! Thanks Reggie!

      Take Care,

      John

      Comment


      • #4
        Thanks John.
        Joe in NY

        Clarke 131E Arc Welder
        HF 4x6 bandsaw
        Hitachi 4.5" Grinder
        Craftsman Air Compressor

        Comment

        Working...
        X