Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

cast aluminum fix on mitre saw

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • cast aluminum fix on mitre saw

    The anchor point that allows the saw's angle to be set broke a couple years back and saved the part in spite of not having access to welding equipment, glad I did. I pre-eated with a heat gun on high for about a minute and set the MM140 to 6/90 but after a blast or two upped it to 7/100. It looks ok. We'll see with use.

    Absolutely delighted that I bought this welder!!! I know this isn't a masterpiece of ingenuity in design and build but it sure feels good fixing broken stuff.







Working...
X
Special Offers: See the latest Miller deals and promotions.